Line is it is it collapse the countermeasure of corner to process to cut
         It does not accord with request of the drawing that the angle collapses, how to avoid collapsing in the angle? Should according to to angle different to take different method pr-ocessing have work piece. The figure angle of work piece has the differences of interior a-ngle and exterior angle, the exterior angle has 3 kinds of solutions, interior angle have one solution, main introduction now prevent exterior angle from collapse the method of corner.
       1 the silk procedure of the electrode continues and extends 0.5mm forward in the corn
er, prevent the electrode from turning round at the corner like this, thus dispelled the angle
of collapsing .
       2 procedure move 0.5mm forward in corner, then is it cut to go back, procedure skew electrode silk radius, part not needed that the angle collapses like this to stay.
       3 procedure set up one procedure of suspending in corner, for example G04X3 (susp-end  3s), electrode silk stay odd seconds in corner, is it lead silk mouth sport to happen partly the middle making, dispel person who delay, then turn round and process, dispel the angle of collapsing for kind.

         Unless when it cut interior angle, let's prevent collapse there aren't horn,can't 1 of op-eration method , 2 of methods, otherwise the part processed is inconsistent with the requ-est.
          The above to is it is it collapse method of horn to prevent to consider from angle that procedure work out, increase electrode tension of silk, is it have , is  it lead silk interval  of mouth to make to shorten , reduce pressure that spray water , change person who leads
silk (quick- wear parts ) can make electrode vibration range of silk reduce, thus of reducing the work piece to collapse the angle amount.